VBM 1350

The powerful prebreaker / grinder system, based on previous WIESER designs, offers
- slowly rotating breaker arms
- screens with hole sizes 6 - 20mm
for high capacity, almost dustless comminution of EPS scraps.

DeDuster

Dust extraction system for EPS regrind,
preferably situated after the fine-grinder, before the regrind silo.
Some dust will occur when using screens with small holes,
therefore it is advisable to configure the recycling plant including a dedusting system.

Layout of a professional EPS recycling plant

1.0 Coarse Regrind Management FOAMLINE HVQ
1.1 Blower Prebreaker TOP Sheet Scrap Recovery
1.2 Blower Prebreaker Side/Front/Rear/Bottom Scrap Sheet Recovery
2.0 Fine Granulation
2.1 Collecting Silo for Coarse Regrind VTS-10
2.2 Metering Airlock Cell Wheel ZRS-50
2.3 Granulator Type VBM 1300 Pro
2.4 Fine Regrind Transportation Blower
3.0 DeDusting Plant
3.1 Collecting Silo for dusty Regrind VTS-10
3.2 Metering Airlock Cell Wheel ZRS-50
3.3 DeDusting System Type VDD 1300
3.4 Transport Blower for clean regrind to silo
3.5 Vacuum Suction Blower for dust transport
3.6 Collecting Silo for dust and contaminant

Mixing Unit

For proper mixture of EPS regrind and virgin material you will need a MIXING and BLENDING station such as the STARMIX system, built by VIRO :

2 Silos with 5 m3 volume each are filled with material (virgin and regrind), rotary airlocks ensure proper mixing according to the percentage ( 0 - 50%) as selected on the control panel. Capacity of up to 150m3/h is just enough to fill the cavities of standard moulds.